DID-E2 Nordic Edition

Design

The coil for waterborne cooling and heating is delivered with two options: standard cooling and combined heating and cooling with two circuits. A suspendable perforated underplate simplifies the cleaning of the coil. The connection for primary air is Ø125 mm or Ø160 mm spiral duct. Connection to water with a Ø12 mm copper pipe. DID-E2 NE has a 50 mm telescopic frame for the secondary grille, and a 150 mm telescopic frame for the frontal grille. The secondary grille is mounted with magnets to simplify the process of cleaning and maintenance of the coil.

MATERIALS AND SURFACES

IMPORTANT. To mount the beam in the roof, the telescopic frame for the front grille has to be taken out, and the secondary grille must be unmounted from the beam.

DID-E2 NE has four mounting brackets for threaded rod. It is recommended to use impact anchors or similar when mounting in concrete. Secondary grille is mounted using four screws, one in each corner. The telescopic frame is pushed into the baffle from the room side until it rests against the wall.

Mounting. When the baffle is secured to the ceiling with threaded rods, the frame for the secondary grille can be fastened back to the rim using four screws. The grille is clamped up to the suspended ceiling and the screws are tightened. Click secondary grille in place. Telescopic frame for front grille is attached to the short sides of the frame with mounting screws, key width 10 mm.

To open the secondary grille, you can use a hook or similar. Gently pull down until the magnets release. The front grille is easily mounted in the telescopic frame. Screws in each short side of the front grille lock against slot grooves in the telescopic frame.